Passenger Foot Pegs Installation Instructions

Compatibility: Dubbel and Ultra with an Ultra Rear Rack installed

Hardware: 

2x M8 x 40mm Bolts - Used for the Dubbel

2x M8 x 20mm Bolts - Used for the Ultra with Ultra rear rack installed

2x M8 Split Washer 

Installation: 

When installing the Foot Pegs on the Blix Dubbel Please use the longer 40mm Bolts, When installing the Foot Pegs on the Ultra with the Ultra rear rack installed please use the shorter 20mm bolts.

Place one washer on each bolt

When installing the Foot Pegs on the Dubbel, there are two locations you can install them. Depending on the height of the rear passenger you may want to place them in a higher or lower position. Note when the pegs are in the higher position they should fold up and towards the rear of the bike 

There is only one position to mount the Foot Pegs on the Ultra Reak Rack, this will be right above where the wheel attaches to the frame.

Place the bolt into the frame from the inside, then position the foot pegs onto the bolt, make sure that the Foot Pegs will fold upwards when placing the foot pegs on the bike, then start to thread them together. Once in position, thread the bolt fully into the Foot Peg and tighten it. Repeat these steps for the other side.